Dellow Big Rear Brakes, Update

The project to fit RS2000 rear brakes to MTT is coming along nicely. I have machined the spacers from quarter inch Ali plate which was ideal and fitted longer wheel studs and then cut off the excess thread to allow the wire wheels to be fitted. A bracket to raise the handbrake rods has been fitted and the brake pipes also slightly modified. All is ready for final assembly and bleeding tomorrow. I have also made two paper gaskets for the axle to bearing flange seal. One side had a gasket and did not leak while the other didn't and did leak. I will also use gasket cement for the final assembly.